26 Mar How To load and unload XRD50: useful tips

In a few simple steps, in this video we show you how to proceed with loading and unloading your XRD50.
SAFETY first! Always make sure that the revolver is unloaded by checking that there are no pellets inside the ammunition mags.
Extract the tab located under the grip of the revolver and unscrew the CO2 chamber cap until fully removed.

At this point, insert the cartridge in the correct direction. To complete the loading operation, screw the chamber cap back on until the cartridge is fully pierced. Once the operation is completed, you will see the loaded revolver warning pin protrude from the back of the gun.

Close the tab located under the grip. At this point, you can remove the safety and the revolver is ready for use.
To correctly insert the ammunition into your XRD50, open the ammunition lock and remove the ammunition mags. Then insert the pellets into the magazine in the correct direction.

Once the operation is completed, place the magazine back into the dedicated slot.

Before unloading your revolver, make sure to secure the revolver.
At this point, press the rear pin with your thumb and completely release the air.

After releasing the air, pull the tab located under the grip and remove the CO2 chamber cap. Complete the operation by removing the cartridge. Finish by placing the closing cap back on in the correct direction.

FOLLOW THE HOW TO VIDEO